• On print, used to lighten a small spot area of a print
• On negative, used to remove silver lightening negative producing a darker print.
• Can also be used on full print.

1. Add 2.5 oz of water
2. Add 1/4 teaspoon potassium ferricynanide
3. Add 1.5 oz of water

1. Pre-soak print(s) in fix for about two minutes, rotating so thoroughly wet.
2. Place print in dry tray with good light
3. Use q-tip or brush to apply bleach (5 secs)
4. Apply fix, with different q-tip or brush, to stop bleaching
5. Repeat steps 3 and 4 as necessary to achieve desired effect
6. After bleaching fix print for about two minutes
7. Wash print normally.

Save mixed bleach, if possible.
Pour down drain and flush with plenty of water. (from Kodak)